JBL 2022H PDF

Hi subwolf, thanks for the info. Do it as well as you possible can. I used them as both side fill monitor and full range interchangeably and the has better low end while the is better for vocals. Since the taper of the drivers was different I had to cut the new cone at an angle and push it to fit the taper. Ie putting a kit in an E and so forth. The letter following the is used to designate the impedence.

Author:Arashidal Faektilar
Country:Zimbabwe
Language:English (Spanish)
Genre:Spiritual
Published (Last):14 April 2018
Pages:249
PDF File Size:14.47 Mb
ePub File Size:6.70 Mb
ISBN:495-2-72548-529-4
Downloads:62213
Price:Free* [*Free Regsitration Required]
Uploader:Tajora



Re: JBL , , I was under the thought that the suffix was also something that showed intent or use of the driver eg- a single driver with a 16ohm impedance would be used for a total 3 or 4 way system impedance of 8 ohms, but a single 4 ohm driver would be used for a 2 way system impedance of 8 ohms One starting point in my confusion I read that someone re-coned a to a , increasing x-maxx how All that being said, my original post was pre-emptive of checking the VC, which didnt seem to be effected at all.

The rip went all the way around the dust cap which made me think that I had totally blown it , and at one point into the middle of the cone. It beat itself so badly that part of the cone was actually soft to the touch, and very weak. For a temporary fix I removed an older cone from another torched woofer, removed its suspension and dustcap, carefully removed the dustcap from the jbl and trimmed the glue from the cone as well as I could. Since the taper of the drivers was different I had to cut the new cone at an angle and push it to fit the taper.

There was a ridge left behind from the old dustcap glue so I had to score the new cone near the former to get it to lay down flat, but once all the pre-fit was done, glue-ing it in wasnt too big of an issue rubber cement Suprisingly enough it didnt sound too bad last night, but a real re-cone kit is in order. Thanks again, guys. Logged "can you make them sing better?

LEUCOPTERNIS ALBICOLLIS PDF

JBL 2032H 15″ Speaker 318219-001X

The is also its own, it is an underhung design with a gap depth of 13mm. Ditto E, E, and It has been quite a few years since I was doing reconing-but I remember that the magnet thickness was different between them. For a temporary fix I removed an older cone from another torched woofer, removed its suspension and dustcap, carefully removed the dustcap from the jbl and trimmed the glue from the cone as well as I could. I thought the magnet slab was thicker. I was under the thought that the suffix was also something that showed intent or use of the driver eg- a single driver with a 16ohm impedance would be used for a total 3 or 4 way system impedance of 8 ohms, but a single 4 ohm driver would be used for a 2 way system impedance of 8 ohms The kit is the same cost as a H. February 21, One starting point in my confusion I read that someone re-coned a to aincreasing x-maxx how I have compared these side by side and could not find any difference in the basket. Logged Brian Elstro Jr.

DWBI CONCEPTS PDF

JBL 2022H 12″ Aftermarket Recone Kit

.

ARCHITECTURE AS SPACE BRUNO ZEVI PDF

JBL 2022H PDF

.

KUMITE GATA PDF

ProSoundWeb Community

.

Related Articles